Polygon Builder
Creates a new polygon builder by copying the parts from the specified Polygon.
The SpatialReference of the new polygon builder will match that of the given Polygon. Use this constructor in workflows that create a modified version of an existing geometry. Polygons with curves are supported.
Since
200.1.0
Parameters
a Polygon from which to start this builder
a trailing lambda parameter from within which to configure the builder.
See also
Creates a new empty polygon builder with the specified SpatialReference.
The SpatialReference cannot be changed after instantiation.
Since
200.1.0
Parameters
a SpatialReference from which to start this builder
a trailing lambda parameter from within which to configure the builder.
Creates a polygon builder with a list of MutablePart.
The spatial reference of the builder will be either the spatial reference of the first part or null if there are no parts.
Since
200.1.0
Parameters
the parts with which to create the builder. All parts must have the same spatial reference.
a trailing lambda parameter from within which to configure the builder.
Creates a polygon builder with a list of points.
The spatial reference of the builder will be either the given spatial reference, or the first Point's spatial reference or null if it is not defined by both.
Since
200.1.0
Parameters
the points with which to create the builder. All points must have the same spatial reference.
a trailing lambda parameter from within which to configure the builder.